![]() Plaster-Weld® can be used over paints having oil, rubber or vinyl bases, and over silicone-treated surfaces, as well as latex paints. Start at the top of the crack and drag the compound down, pushing it into the crack as. Using the putty knife, apply a thin coat of joint compound to the crack. Look for compound, paint flakes, and other debris in the crack and scrape it out. sheet lead in x-ray rooms) and marble are suitable sound surfaces, structurally. Start the project by cleaning up the crack with the utility knife. PUTTY: fills cracks and crevices in plaster, PLASTER-WELD by. Concrete, brick, block, glass, ceramic tile, wallboard, metals (e.g. A notable change was the elimination of ceiling mouldings now plaster met. Weld Crete or a similar bonding agent are necessary if youre re-finish over a. Plaster-Weld® prepares the surface to allow you to plaster directly to concrete over electric radiant heat cable, and to bond cement mortar beds to smooth concrete for installation of rigid foam insulation. 9902) permanently bonds new concrete, plaster, and stucco to existing. Move immediately to the next step, as the joint compound dries rapidly. ![]() Scoop up a small portion with a 6-inch drywall knife, and smooth a thin layer of joint compound over the crack, making a path that's a little wider than the paper tape. Manufacturing changes at the end of the 19th century made it possible to use gypsum as a plastering material. Mix the drywall joint compound, as needed. The lime came from ground-and-heated limestone or oyster shells the aggregate from sand and the fiber from cattle or hog hair. DESIGNED FOR INTERIOR USE ONLY, the high performance bonding of one-coat finish plaster and/or two and three coat work to concrete ceilings, walls, columns, beams, and other structurally sound surfaces. Lime plaster was made from four ingredients: lime, aggregate, fiber, and water. The original chemical plaster bonding agent is a patented formulation incorporating polyvinyl acetate homopolymer. ![]() However you do need to make sure you scratched the scratch coat properly, and you do need to dampen an existing coat of plaster before you put on the new wet plaster. Plaster-Weld® bonds new plaster to any clean, structurally sound, interior surface. 1 You shouldn't need a bonding agent, for putting a base coat on a scratch coat, or a finish coat on a base.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |